聯系電話
上海北諾生物科技有限公司
中級會員·13年
- 聯系人：
- 周經理 劉經理
- 電話：
- 021-57730393
- 手機：
- 15800960770
- 傳真：
- 86-021-61496710
- 地址：
- 上海市徐匯區宜山路520號中華門大廈18樓D座
- 個性化：
- www.bnbiotech.com
- 網址：
- www.bnbiotech.com
掃一掃訪問手機商鋪
實驗試劑
Bacterium preparation
Cryoprotective agent
TrueCoolTM cryovial
實驗設備
CoolBoxTM CFT30 ice-free cooling station
CoolRack® CFT30
CoolRack® CF
Cryolabels and/or cryomarkers
ThermalTrayHP platform （optional）
CoolSinkTM BX50 （optional）
37°C waterbath
-80°C Freezer
實驗步驟
1. Bacteria Preparation
Follow the laboratory protocol for bacterial growth and preparation.
Refer to CDC （Centers for Disease Control and Prevention） guidelines for utilization of pathogens in specific BSL （Biosafety Level）. Pathogens are infectious agents and should be manipulated in a controlled and safe environment.
2. Bacteria Freezing
1） As a general rule, maintain the bacterial preparation at 4°C by placing it in a boat-reservoir in CoolSinkBX50 and/or ThermalTray on ice.
2） Prepare a bacteria glycerol stock by diluting the bacterial preparation with a sterile glycerol solution for a final 15-50% v/v glycerol concentration. Dispense 1 ml of stock （or desired amount） in a pre-labeled TrueCool cryovial. To avoid titer reduction maintain the vials on a CoolRackCFT30 in the CoolBox at 4°C. The CoolRackCFT30 reduces contamination and spill accidents by allowing one-handed opening/closing of the cryovials.
3） While bacteria samples are kept cold at 4°C in the CoolRackCFT30, equilibrate a CoolRackCF on dry-ice for 10 minutes. Note: with this protocol, there is no need to make a dry-ice/ethanol slurry. Place the cryotubes directly on the pre-equilibrated CoolRackCF and snap-freeze the samples for 3-5 minutes.
4） Transfer the frozen samples to a storage box and place it in the -80°C freezer for long-term storage.
3. Bacteria Thawing
1） Place the cryovials from the -80°C freezer in a CoolBoxCFT30 with a -12°C frozen cartridge inside to maintain the vials at the correct temperature and allow transport of the vials in a safe manner.
2） Place the vials directly in a 37°C water bath, and manually slowly agitate the vials to enable the thawing process. Just before the whole liquid is compley thawed, remove the vial from the 37°C water bath and place it on a CoolRackCFT30 previously equilibrated on ice. Samples are ready for experimental procedures or titer assessment.
